Bài 19 với ạ, ai giúp em với ❤️❤️❤️❤️❤️

Answer:

0.7602 g/L

Explanation:

We'll begin by calculating the molar mass of NH₃. This can be obtained as follow:

Molar mass of NH₃ = 14.01 + (3×1.01)

= 14.01 + 3.03

= 17.04 g/mol

Finally, we shall determine the density of ammonia, NH₃. This can be obtained as follow:

Temperature (T) = 273 K

Pressure (P) = 1 atm

Molar mass of NH₃ (M) = 17.04 g/mol

Gas constant (R) = 0.0821 atm.L/Kmol

Density (D) =?

D = PM / RT

D = (1 × 17.04) / (0.0821 × 273)

D = 17.04 / 22.4133

D = 0.7602 g/L

Answer:

It is A

Explanation:

Answer:

There are main six noble gases in the periodic table. The filling of 4f-orbitals occurs after 6s orbitals. The noble gas that belongs to the sixth period is Radon. Its electronic configuration is [ X e ] 6 s 2 4 f 14 5 d 10 6 p 6  .

Therefore, the name of noble gas is Radon.

Isotopes are atoms of the same element that have different masses. The relative atomic mass (am) is a weighted average that takes into account the abundance of each isotope. We can calculate the relative atomic mass using the following expression.

[tex]am = \frac{\Sigma m_i \times ab_i}{100}[/tex]

where,

For Gallium,

[tex]70.59 amu = \frac{69 amu\ x + 71 amu\ y}{100}[/tex]     [1]

where "x" and "y" are the unknown abundances.

We also know that the sum of both abundances must be 100%.

x + y = 100

y = 100 - x   [2]

If we replace [2] in [1], we get

[tex]70.59 amu = \frac{69 amu\ x + 71 amu\ (100-x)}{100} \\7059 amu = -2 amu\ x + 7100amu \\x = 20.5[/tex]

Then, in [2]

y = 100 - x = 100 - 20.5 = 79.5

In conclusion, Ga-69 has an abundance of 20.5% and Ga-71 has an abundance of 79.5%.

You can learn more about isotopes in: https://brainly.com/question/21536220?referrer=searchResults

Answer:

2H2S (g) + 3O2 (g) = 2H2O (l) + 2SO2 (g)

▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓

[tex]\boxed{\pmb{\green{\sf{2H_{2}S(g) + 3O_{2}(g)\dashrightarrow 2H _{2}O(l)+2SO_{2}(g)}}}}[/tex]

▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓

Answer:

rubbing the ruler transfers electrons from the clothe to the ruler now the ruler has excess electrons and it is negatively charged... electrons will move away from the ruler leaving a positive charge on the tissue near the ruler so they attach

I hope this helps

Answer:

increase temperature, increase surface areas, add catalyst, stir

The rate of reaction can be increased with the increase in temperature, surface area, adding catalyst and allowing stirring. Thus, option C is correct.

The rate of reaction is given as the rate of formation of product or the rate of disappearance of reactant in unit time.

The rate of reaction can be affected with:

Thus, the rate of reaction can be increased with the increase in temperature, surface area, adding catalyst and allowing stirring. Thus, option C is correct.

Learn more about rate of reaction, here:

https://brainly.com/question/13440548

#SPJ2

Answer:

Specific heat capacity is measured by determining how much heat energy is needed to raise one gram of a substance one degree Celsius. The specific heat capacity of water is 4.2 joules per gram per degree Celsius or 1 calorie per gram per degree Celsius

Explanation:

hiiiiiiiii

hiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii

Answer:

light

Explanation:

Have a nice day

Answer:

light

Explanation:

Explanation:

For example, elephants form groups with only females and their offspring. Once the male offspring reach a certain age, they leave the group and become solitary. Which is a benefit of this type of social group structure? A:Females do not have to compete for a mate.

Answer:

They are good electrolytes

Answer:

C. The volume stays the same, but the shape changes to fit the new container.

Explanation:

It changes shape to fit the container since it's a liquid.

Answer:

Nuclear energy.

Explanation:

It's the energy that holds protons and neutrons ( nucleons ) together, hence holds the nucleus as one.

Answer:

C

Explanation:

C. Adding a catalyst would increase the reaction rate.

A catalyst is a substance that increases the rate of a chemical reaction by lowering the activation energy required for the reaction to occur.

A catalyst enhances the probability of successful collisions between reactant molecules, which raises the pace of the reaction by offering an additional avenue for the reaction to occur.

As there would be fewer reactant molecules accessible to react with one another, decreasing reactant concentrations would result in a slower pace of reaction.

Due to the fact that chemical reactions often require energy to take place, eliminating heat from the system would also slow down the reaction rate. A lower value for k would result in a lower rate constant, which would lower the response rate.

Learn more about catalyst at:

https://brainly.com/question/24430084

#SPJ7

Answer:

B. Transfer energy to reaction center chlorophylls.

Explanation:

Accessory pigments absorbs sunlight, these compounds are found in photosynthetic organisms, which work in conjunction with chlorophyll. Acessory pigments absorbs and transfer light energy to reaction center chlorophylls.

Answer:

how will I show?

Explanation:

pLS teacher me

Answer:

No, it is not feasible because the Gibbs free energy change is positive

Explanation:

∆Hreaction= (-602 KJ/mol) - (-348 KJ/mol) = -254 KJ/mol

∆Sreaction = (42 + 27) J/Kmol - (33 + 44) J/K = -8J/Kmol

From;

∆G = ∆H - T∆S

∆G = 254 × 10^3 J/mol - [340K × (-8 J/Kmol)]

∆G = 2.57 × 10^5 J/mol

Note that when the change in free energy is positive, a reaction is non spontaneous. Only a reaction that has a negative change in free energy is spontaneous.

Answer:

B. Yes, it is feasible because the Gibbs free energy change is negative.

Explanation:

I passed the exam 100/100

Answer:

5.ethanol and carbon dioxide

6.it contains ethyl alcohol which can be effective at killing viruses and bacteria

Answer:

sry i don't know answer of This question

Answer:

Trial Y, because the volume of product per unit time is lower than Trial X

Explanation:

In the chemistry experimental setup, the amount of gaseous product formed by the different concentration of the trials are measured and the result is plotted on a graph

The given graph, shows;

The vertical, y-axis = The amount of product

The horizontal, x-axis = Th time of the reaction

Trial X = The graph line with a steeper slope

Trial Y = The graph line

Increase in the concentration f the reactants, increases the number of collisions, and therefore, the number of effective collisions that gives the product also increases, and the overall rate of reaction increases

A more concentrated reactants produce more product in a shorter time (yield more product in less time) than a less concentrated one, and a more concentrated reactant would have a steeper slope and therefore produce more volume of the product in less time than a less concentrated reactant, which produces a lower volume in the same time

Therefore, the trial that has a lower concentration of the reactant is Trial Y, because the volume of product per unit time is lower than Trial X.

Answer:

There ya go

Explanation:

The products formed during electrolysis of concentrated sodium chloride solution are SODIUM HYDROXIDE and HYDROGEN GAS.

ELECTROLYSIS is the process by which electrolytes allows electric current to pass through it and is decomposed on the process.

CHLORINE is an element which can be produced industrially through the process of electrolysis of brine (concentrated sodium chloride solution). When sodium chloride is dissolved in water, it's ions separate and are capable of conducting electricity.

The products formed during this process includes:

CHLORINE: this is released at the positive electrode during electrolysis. It is used for the following purposes:

SODIUM HYDROXIDE: this remains in the solution during electrolysis. It is used for the following:

HYDROGEN GAS:this is released at the negative electrode during electrolysis. this is used for the following:

Therefore other products during electrolysis of concentrated sodium chloride solution are SODIUM HYDROXIDE and HYDROGEN GAS.

learn more here:

https://brainly.com/question/13123512

Answer:

Amino Acid

Explanation:  

It's part of the Amino group, which are substituted hydrocarbons.

When NH₂  and  COOH  replaces hydrogens on the same carbon atom in a molecule, an Amino acid is formed.

What group is a COOH?

COOH : a Carboxylic Acid group!

Answer:

The FitnessGram™ Pacer Test is a multistage aerobic capacity test that progressively gets more difficult as it continues. The 20 meter pacer test will begin in 30 seconds. Line up at the start. The running speed starts slowly, but gets faster each minute after you hear this signal. [beep] A single lap should be completed each time you hear this sound. [ding] Remember to run in a straight line, and run as long as possible. The second time you fail to complete a lap before the sound, your test is over.

Answer: The hydroboration of an alkene occurs in TWO CONCERTED STEP which places the boron of the borane on the LESS SUBSTITUTED carbon of the double bond. The oxidizing agent then acts as a nucleophile, attacking the electrophilic BORON and resulting in the placement of a hydroxyl group on the attached carbon. Thus, the major product of the hydroboration oxidation reaction DOES NOT follow Markovnikov's rule.

Explanation:

Hydroboration is defined as the process which allows boron to attain the octet structure. This involves a two steps pathway which leads to the production of alcohol.

--> The first step: this involves the initiation of the addittion of borane to the alkene and this proceeds as a concerted reaction because bond breaking and bond formation occurs at the same time.

--> The second step: this involves the addition of boron which DOES NOT follow Markovnikov's rule( that is, Anti Markovnikov addition of Boron). This is so because the boron adds to the less substituted carbon of the alkene, which then places the hydrogen on the more substituted carbon.

Note: The Markovnikov rule in organic chemistry states that in alkene addition reactions, the electron-rich component of the reagent adds to the carbon atom with fewer hydrogen atoms bonded to it, while the electron-deficient component adds to the carbon atom with more hydrogen atoms bonded to it.

2HCl + Mg => MgCl2 + H2

Answer:

Iconic bond

Explanation:

Answer:

The limiting reagent is CuCl

Explanation:

The initial number of moles of aluminum, Al = 4.5 moles

The number of moles of copper, Cu = 6.5 moles

The given chemical reaction is presented as follows;

2Al + 3CuCl → 2AlCl₃ + 3Cu

Therefore, we have, 2 moles of aluminum combine with 3 moles of CuCl produces 2 moles of AlCl₃ and 3 moles of Cu

1 mole of Al will combine with (3/2) moles of CuCl,

Therefore, 4.5 moles of Al will combine with (4.5 × (3/2) = 6.75) 6.75 moles of CuCl

Given that the number of moles of CuCl present is only 6.5 moles which is less than the 6.75 moles required to combine with the 4.5 moles, the 6.5 moles of CuCl limits the amount of AlCl₃ and Cu produced, and therefore the CuCl is the limiting reagent.