how do I know which substance is being reduced? ​

Explanation:

Answer is that : no heat will flow

Answer:

Heat will flow from the ice cube to the dry ice

Explanation:

The products formed during electrolysis of concentrated sodium chloride solution are SODIUM HYDROXIDE and HYDROGEN GAS.

ELECTROLYSIS is the process by which electrolytes allows electric current to pass through it and is decomposed on the process.

CHLORINE is an element which can be produced industrially through the process of electrolysis of brine (concentrated sodium chloride solution). When sodium chloride is dissolved in water, it's ions separate and are capable of conducting electricity.

The products formed during this process includes:

CHLORINE: this is released at the positive electrode during electrolysis. It is used for the following purposes:

SODIUM HYDROXIDE: this remains in the solution during electrolysis. It is used for the following:

HYDROGEN GAS:this is released at the negative electrode during electrolysis. this is used for the following:

Therefore other products during electrolysis of concentrated sodium chloride solution are SODIUM HYDROXIDE and HYDROGEN GAS.

learn more here:

https://brainly.com/question/13123512

Isotopes are atoms of the same element that have different masses. The relative atomic mass (am) is a weighted average that takes into account the abundance of each isotope. We can calculate the relative atomic mass using the following expression.

[tex]am = \frac{\Sigma m_i \times ab_i}{100}[/tex]

where,

For Gallium,

[tex]70.59 amu = \frac{69 amu\ x + 71 amu\ y}{100}[/tex]     [1]

where "x" and "y" are the unknown abundances.

We also know that the sum of both abundances must be 100%.

x + y = 100

y = 100 - x   [2]

If we replace [2] in [1], we get

[tex]70.59 amu = \frac{69 amu\ x + 71 amu\ (100-x)}{100} \\7059 amu = -2 amu\ x + 7100amu \\x = 20.5[/tex]

Then, in [2]

y = 100 - x = 100 - 20.5 = 79.5

In conclusion, Ga-69 has an abundance of 20.5% and Ga-71 has an abundance of 79.5%.

You can learn more about isotopes in: https://brainly.com/question/21536220?referrer=searchResults

Answer:

The limiting reagent is CuCl

Explanation:

The initial number of moles of aluminum, Al = 4.5 moles

The number of moles of copper, Cu = 6.5 moles

The given chemical reaction is presented as follows;

2Al + 3CuCl → 2AlCl₃ + 3Cu

Therefore, we have, 2 moles of aluminum combine with 3 moles of CuCl produces 2 moles of AlCl₃ and 3 moles of Cu

1 mole of Al will combine with (3/2) moles of CuCl,

Therefore, 4.5 moles of Al will combine with (4.5 × (3/2) = 6.75) 6.75 moles of CuCl

Given that the number of moles of CuCl present is only 6.5 moles which is less than the 6.75 moles required to combine with the 4.5 moles, the 6.5 moles of CuCl limits the amount of AlCl₃ and Cu produced, and therefore the CuCl is the limiting reagent.

Answer:

Nuclear energy.

Explanation:

It's the energy that holds protons and neutrons ( nucleons ) together, hence holds the nucleus as one.

Answer:

Following are the solution to the given question:

Explanation:

Its maximum oxidation zone is exceptionally stable and has the greatest ability to charge density, while fluoride and oxide ions are the largest particles with the largest durability of charge.

Or it might be assumed as oxygen and fluorine are the system particle atoms that have the highest electron number of metals.

Answer:

light

Explanation:

Have a nice day

Answer:

light

Explanation:

Answer:

Specific heat capacity is measured by determining how much heat energy is needed to raise one gram of a substance one degree Celsius. The specific heat capacity of water is 4.2 joules per gram per degree Celsius or 1 calorie per gram per degree Celsius

Explanation:

Answer:

It is called bleaching oxidation process.

Answer:

increase temperature, increase surface areas, add catalyst, stir

The rate of reaction can be increased with the increase in temperature, surface area, adding catalyst and allowing stirring. Thus, option C is correct.

The rate of reaction is given as the rate of formation of product or the rate of disappearance of reactant in unit time.

The rate of reaction can be affected with:

Thus, the rate of reaction can be increased with the increase in temperature, surface area, adding catalyst and allowing stirring. Thus, option C is correct.

Learn more about rate of reaction, here:

https://brainly.com/question/13440548

#SPJ2

Answer:

The FitnessGram™ Pacer Test is a multistage aerobic capacity test that progressively gets more difficult as it continues. The 20 meter pacer test will begin in 30 seconds. Line up at the start. The running speed starts slowly, but gets faster each minute after you hear this signal. [beep] A single lap should be completed each time you hear this sound. [ding] Remember to run in a straight line, and run as long as possible. The second time you fail to complete a lap before the sound, your test is over.

Answer:

C. The volume stays the same, but the shape changes to fit the new container.

Explanation:

It changes shape to fit the container since it's a liquid.

Answer:

5.ethanol and carbon dioxide

6.it contains ethyl alcohol which can be effective at killing viruses and bacteria

Answer:

sry i don't know answer of This question

Answer:

2H2S (g) + 3O2 (g) = 2H2O (l) + 2SO2 (g)

▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓

[tex]\boxed{\pmb{\green{\sf{2H_{2}S(g) + 3O_{2}(g)\dashrightarrow 2H _{2}O(l)+2SO_{2}(g)}}}}[/tex]

▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓

Answer:

c

Explanation:

Cạnh của hình lập phương là

³\(125 = 5cm

Diện tích đáy của hình lập phương là

5²=25cm²

Đáp án C

Answer:

Trial Y, because the volume of product per unit time is lower than Trial X

Explanation:

In the chemistry experimental setup, the amount of gaseous product formed by the different concentration of the trials are measured and the result is plotted on a graph

The given graph, shows;

The vertical, y-axis = The amount of product

The horizontal, x-axis = Th time of the reaction

Trial X = The graph line with a steeper slope

Trial Y = The graph line

Increase in the concentration f the reactants, increases the number of collisions, and therefore, the number of effective collisions that gives the product also increases, and the overall rate of reaction increases

A more concentrated reactants produce more product in a shorter time (yield more product in less time) than a less concentrated one, and a more concentrated reactant would have a steeper slope and therefore produce more volume of the product in less time than a less concentrated reactant, which produces a lower volume in the same time

Therefore, the trial that has a lower concentration of the reactant is Trial Y, because the volume of product per unit time is lower than Trial X.

Answer:

There ya go

Explanation:

Answer:

Zn + O2 = ZnO

Mg + O2 = MgO

Cu + O2 = CuO

Al + O2 = Al2O3

Explanation:

Answer:

They are good electrolytes

Answer:

B. Transfer energy to reaction center chlorophylls.

Explanation:

Accessory pigments absorbs sunlight, these compounds are found in photosynthetic organisms, which work in conjunction with chlorophyll. Acessory pigments absorbs and transfer light energy to reaction center chlorophylls.

Answer:

Amino Acid

Explanation:  

It's part of the Amino group, which are substituted hydrocarbons.

When NH₂  and  COOH  replaces hydrogens on the same carbon atom in a molecule, an Amino acid is formed.

What group is a COOH?

COOH : a Carboxylic Acid group!

Answer:

s orbital

Explanation:

it has the lowest energy because

Paulis law state that orbitals with lower energy must be fill first before that of higher energy

and the s orbital is filled first

hiiiiiiiii

hiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii

Answer:

B. Protons and Neutrons

Answer:

Option"B" is correct.

MARK ME BRAINLISTS

Answer:

There are main six noble gases in the periodic table. The filling of 4f-orbitals occurs after 6s orbitals. The noble gas that belongs to the sixth period is Radon. Its electronic configuration is [ X e ] 6 s 2 4 f 14 5 d 10 6 p 6  .

Therefore, the name of noble gas is Radon.

Answer:

Pertaining to the interrogate, the answer to such is acknowledged and henceforth disseminated as 43.0%

Explanation:

To evaluate such, the following must be comprehended:

Percent Yield Calculator:

% Yield = (What You Actually Got / What You Should Theoretically Get) * 100

The following variables may be denoted, as stated within the interrogate:

Yielded/Produced: 6 grams.

Theoretical Yield: 14 grams.

(6 g/14 g) * 100 = 42.8571428571

*Grams measurement cancels*

42.8 ==> 43.0%

Thus, if rounded to the nearest tenth, the percent yield is equivalent to 43.0%.